Over Charge Detection Voltage, VOC
4.50 VBAT Monitor VBAT to release VOC
Over Discharge Detection Voltage
VOD : 2.80VBAT
Load Short Circuit Protection with Delay Time to avoid a false trigger
Activated by Applying VON to the VOUT Pin from Charger
1.5A Continuous Charging Current Capability from VOUT to VBAT Pin
Low RON
36 mΩ Typ. @ 3.6 VBAT
Quiescent Current
IQ = 720 nA Typ @ 3.6 VBAT
Shutdown Current
ISD 70nA Typ @ VBAT < VOD
Latch-off at Over Discharge Detection and Short Circuit Protection. Apply VON to VOUT pin to turn on again
Near 0V Battery Charging
0.4V Minimum Battery Voltage for Charging
Patent Pending Circuit Architecture
HBM / CDM
8kV / 2kV
Chip Scale Package 4 Bumps
0.97 mm x 0.97 mm x 0.55 mm, 0.5 mm Pitch
The GLF73910-BD01 is an IQSmartTM ultraefficient, full battery protection switch with an accurate over charge voltage, over discharge voltage, and short circuit protection for lithiumIon/Polymer battery safety.
The over charge and discharge voltage protections keep a rechargeable battery working within the desired safe operating condition. When the battery is charged past the over voltage detection level, the GLF73910-BD01 switch opens in a preset delay time.
As the battery voltage decreases below the over discharge detection voltage level, the GLF73910-BD01 switch is turned off immediately to cut off the battery power rail, consuming an ultra-low leakage current (ISD) to save the battery. In addition, when the load current reaches the ISC short circuit protection level, the GLF73910- BD01 switch is turned off and will maintain the off state to avoid any serious damage to system. The short circuit delay time avoids any false trigger which might open the switch.
When a charged battery cell is connected, the GLF73910-BD01 remains in the off state and consumes an ultra-low leakage current (ISD) until the VON voltage is applied to VOUT pin. Note that the GLF73910-BD01 is activated only by a VON voltage from a charger output.